Motorola MotoTrbo radios, DMR and anaolgue

Functions

The virtual control head gives you full control of the radio, just as if you were sitting in front of it. All buttons can be accessed from your touch screen, with the mouse or by short cuts on the standard keyboard. And you have a full copy of the radios display.

The radio can be programmed for analogue channels, DMR or even DMR TIER3, the remote control will handle all systems since it works as a remote for the display and the keyboard. What is programmed into the radio doesn´t matter.

All connections are made from the rear connector on the radio. The standard control head should be left on the radio and will work in parallel with the Virtual Control Head.

As with all other SoftRadio you can operate several radios from one dispatcher and each radio can be operated from several dispatchers. Each dispatcher can also use other types of radios in a mix.

Network Interface: 3009/16
CableKit: 3022/02

In Europe (EMEA) the radios we work with are known as DM3600/DM3601 and DM4600/DM4601. See table below for numbering in Asia and America.

20E A brochure can be found on the download page

Cost saving alternative
The radios below and also other MotoTrbo radios (DM2600, DM4400 etc.), can also be remote controlled through a smaller interface. This gives remote of only audio and PTT, without a virtual control head.

You then need the Network Interface LE and a cable kit. The operator software is the same. It will give you voice functionality, but no virtual control head or channel control.

Examples of use:

Local use when several dispatchers want to share one radio
Remote use where a dispatcher at one location want to talk to radio users at a different location
CrossPatch between DMR channels and other two way radios, like analogue, IDAS, Marine, Tetra or Airband

Supported Radio Models:

DM4600-front-1

DM4600 / DM4601

Also known as:
XPR5550, XPR5580,
DGM5500, DGM8500,
XiR M8660, XiR M8668

The e-versions also works

New Project (1) DM3600 / DM3601

Also known as:
XPR4500, XPR4550,
XPR4580, XiR M8260,
M8268, DGM6100

Radio keypad

We have also added the keyboard from the keypad microphone on the Virtual Control Head to make it easier to make calls.

On the DM4600-series you can, in the radio, program the keyboard to be used for Channel Select as default. This is very practical if you have many channels in the radio. For example if the radio is programmed as a marine VHF radio. Just key in the channel number and press OK to make a channel change.

Menues

Examples of menues shown on the DM4600 Virtual Control Head

DM4600-4

Comments

No hardware changes are needed in the radio.
The radio shall be programmed for:

Cable Type on the Accessories Page, set to: “Rear Data Accy”
GPIO Pin #17 shall be set to Ext Mic PTT, active low
GPIO Pin #26 shall be set to “Ext Alarm; High”
Alarm to “Permanent Ext Alarm”

If your radio has different labels on the buttons than the European radios, please contact us and we will try to change the virtual control head for you.

Installations with the old radio type can be upgraded to run with the new radio by changing the interface firmware (4.148 or later) and running the latest Mimer SoftRadio (3.3.10.6 or later).